Please enter the article no. from our catalogue.
Interface adapter for Red Dragon« 3 Speedy pump with 10V connection
Technical data interface adapter Red Dragon« 3 Speedy pump 50/60/80/100W :
for the connection of your Red Dragon« 3 pump with 10V connection to your aquarien-computer/controller
with all neccessary connection-cables
ready for use
contents of delivery:
Dimension controller: 145 mm length / 85 mm wide / ~ 55 mm height
Use the RD3 pump as a circulation pump!
Watch, how it works! Link to the video.
This controller allows a connection to an aquarium computer (E.g. GHL) via a 0-10V interface.
Please choose your right voltage (120V or 230V) and connection-cable (Apex/ReefAi or GHL)!
Tested so far following these computers:
GHL ProfiLux 3.1 + 4, from Neptune Systems the Apex Aqua Controller and with SciTronix littleblue.
The pulsing is in 5s intervals possible.
Functioning of the electronics:
Once a voltage > 0,5V to the 10V interface is, the interface adapter takes over controlling and the system and lock(disable) the buttons on the controller. Voltage will be < 0,5V normal controller operation and the buttons are again released. So can the interface adapter stay connected without performing a function.
If the Aquarium(tank)-computer voltage under 0,5V the 0-10V interface is shut down and the pump can be operated manually. From 0,5V, the interface will take over control of the scheme. In the area of 0,5V-0,8V the pump is switched off. 1V starts the pump at the lowest level (15W) and run. At an increase of 0,5V will increase the level, also. So 1V = 15W 1,5V = 20W 2V = 25W….. 5,0V = 50W, 6,0V = 60W, 7,5V = 80W, 10V = 100W.
At a higher input voltage remains the Speedycontroller to the maximum setting are available and no longer increases. The interface adapter behaves as if the corresponding would push the button.
for slot pipe Ø 40 and 50mm red
100 Watt/h 6,0 mtr. pressure height
speed adjustable Brushless DC pump
with Hirschmann plug
and prepared 10V connection
HIGH PRESSURE VERSION